The kit consists of a dial gauge holder that is screwed into the specific seats on each of the robot axes and a centesimal dial gauge to find the correct calibration position.
|
|
10-inch and 100-millimetre sine bars. In the U.S., 5-inch sine bars are the most common size. Angles are measured using a sine bar with the help of gauge blocks and a dial gauge or a spirit level. The aim of a measurement is to measure the surface on which the dial gauge or spirit level is placed horizontally.
|
|
A more sophisticated variation of the beam type torque wrench has a dial gauge indicator on its body that can be configured to give a visual indication, or electrical indication, or both when a preset torque is reached.
|
|
Welding regulators, unlike simpler LPG heating regulators, retain their outlet (hose) pressure gauge and do not rely on the calibration of the adjustment knob. The cheaper single-stage regulators may sometimes omit the cylinder contents gauge, or replace the accurate dial gauge with a cheaper and less precise "rising button" gauge.
|
|
Two datum points will exist instead of one since the base is V-shaped. The error in roundness can be measured similar to the previous method. #Also a cylindrical body can be clamped between two axle centres. Here also the dial gauge is mounted over the cylindrical body and thus the roundness is measured by similar procedure as above.
|
|
Dial indicators typically measure ranges from 0.25 mm to 300 mm (0.015in to 12.0in), with graduations of 0.001 mm to 0.01 mm (metric) or 0.00005in to 0.001in (imperial/customary). Various names are used for indicators of different types and purposes, including dial gauge, clock, probe indicator, pointer, test indicator, dial test indicator, drop indicator, plunger indicator, and others.
|
|
Ideally an eggshell fragment being used to estimate the full size of an egg should be more than 3 cm long. Smaller eggshell fragments are better suited to other methods of study, like the Obrig radius dial gauge. The Geneva Lens measure gives units in diopters which must be converted to the radius in millimeters. Use of the Geneva Lens Measure to estimate the size of a fossil egg was first done by Sauer on fossil ostrich eggs.
|
|
Like the other 650-cc models, the Trophy gained unit construction in 1963. Coil ignition replaced the magneto. For 1964, the bike received stronger front forks, which improved handling. The Smiths Chronometric instruments were replaced by the magnetic type. In 1965, a locating pin for finding top dead center was added to allow timing without the use of a dial gauge. In 1966, the tank badge style changed from the "Harmonica" style to the "Eyebrow". Confusingly, the model designators for the US now reverted to TR6R and TR6C. The electrics changed to 12 volts, and a bigger 6-pint oil tank was added.
|
|
In the 1970s, Williams presented the intelligent face of bikers at public appearances giving open lectures at universities. He provided insight into the engineering issues of racing the restricted budget Works Norton against multi-cylinder bikes from Japan, highlighting the pros and cons of using the 1940s designed Norton engine. The crank shaft of the 360 degree parallel twin was supported on only two main bearings and as more power was developed from the engine a noticeable flex could be measured using a dial gauge placed on the end of the shaft. In the later 1970s Williams operated a Kawasaki motorcycle dealership in Southampton.
|
|